Cumpara acum Retelistica > Echipamente Pentru Retele Wireless > Antene, Boostere, Conectica, Accesorii > Boostere 2,4GHz, Splittere 2,4GHz, Adaptoare Si Conectica

Repotec RP-WR1201G - Auto-Gain Booster for 802.11g

The device is an outdoor solution bi-directional Amplifiers designed for 2.4GHz wireless LAN. It comes with an easy plug-and-play installation, which works together with an indoor Wireless Access Point to improve its operation range and performanta. The unit is ideal for use with 2.4GHz Frequency Hopping or Direct Sequence Spread Spectrum radio modems and 11Mbps IEEE 802.11b devices. The amplifiers increase range by providing transmit gain as well as low-noise receive gain. This receive gain increases the receive sensitivity of wireless LAN Access PoINTERIOR

FEATURES

Maximizing broadband and distance in wireless communication

High gain and high performanta

Support point to point connectivity for long distance without the use of cable

Lightning protection

Cast alumimum construction

SPECIFICATIONS

Operating Range	2400-2500MHz
Operating Mode	Bi-directional, half duplex, Time Division Duplex Senses RF carrier from Transmitter and automatically switches receive to transmit mode
Transmit Gain	30dB (automatically adjusted)
Frequency Response	± dB over operating range
Output Power	1W (+31dBm) nominal; 500mW (+27 dBm) nominal
TX Input Power	(0dBm) minimum, up to (+20dBm) maximum
Receiver Gain	15dB typical
Noise Figure	3.5dB typical
Connectors	N-type, female, 50ohm
Lightning Protection	Direct DC ground at antenna connector
DC surge protection	at 6 V DC input from transmission cable
Power Consumption	1A at 6 V DC 105-240V AC from power supply
Dimensions (cm)	Bi-directional amplifier: 4.92"L x 2.76"W x 1.02"H 5V/1A DC injector: 3.14"L x 2.23"W x 1.02"H
Humidity	Bi-directional amplifier: up to 100% Relative Humidity 5V DC injector: 10% to 75% Relative Humidity
Operating Temperature	Bi-directional amplifier: -20°C to +70°C 5V DC injector: -30°C to +70°C

 Boostere 2,4GHz, Splittere 2,4GH